Спасибо!

Мы исправим ошибку в ближайшее время

Сообщить об ошибке

Site Tools


Sealing

For Omnicomm LLS sensors, the bolt or the self-tapping screw and the connection may be sealed as shown below: Sealing of the bolt Sealing

1. Install the bolt or the self-tapping screw through a hole in the seal

2. Close the seal cover with a snap

3. Enter the seal and cover numbers in the report

Install the seal-tie on Omnicomm LLS-AF 4 connector:

Sealing of the connector

  1. Connect Omnicomm LLS-AF 4 connector to the mounting cable until it clicks
  2. Run the flexible part of the seal through the connectors
  3. Run the flexible part of the seal through the hole in the seal body
  4. Tighten up the connection
  5. Cut off the extended section of the flexible part of the seal