Спасибо!

Мы исправим ошибку в ближайшее время

Сообщить об ошибке

Site Tools


Sensor Preparation

  1. Measure the depth of the tank. Cut the sensor measuring piece so that its length is 20mm less than the depth of the tank. Ensure that the shearing line is perpendicular to the sensor's longitudinal axis
  2. Use oil-and-petrol resistant non-conductive sealant to fill the insulation cap (included in the kit) to 1/4–1/5 of its volume. Recommended sealants: PERMATEX™ MotoSeal® Black, ABRO™ Black, ABRO™ Red
  3. Put the insulation cap on the central rod of the Omnicomm LLS sensor