Specifications

Parameters	Value
Parameters	LLS 30160	LLS-AF 4
Power supply voltage, V	7 – 75	7 – 45
Power consumption, W	0,4	Typical – 0,6 Maximum – 0,9 During a short-circuit on an analog output – 1,6
Measurement range, mm	0…700, 1000, 1500, 2000, 2500, 3000	0…700, 1000, 1500
Basic reduced error of measurement of the sensor, %	±1
Ambient temperature, °С	From -40 to +80
Limit temperature, °С	-60 and +85
Relative humidity at 25 °С (without moisture conden-sation), %	From 5 to 95
Atmospheric pressure, kPa	From 84 to 107
Maximum relative humidity at 25 °С (without moisture condensation), %	100
Ingress protection rating	IP57	IP69k
Operating mode	Continuous
Internal filter size	From 0 to 30
Measurement time period, s	1
Overall dimensions, cm	78х74х(24+length of the measuring probe)
Weight, kg	Not more than 2
Average service life, years	8

Omnicomm LLS 30160
Output interface for measured values	RS-232, RS-485
Programmable interface transmission rate, bit/s	1200, 2400, 4800, 9600, 19200, 38400, 57600, 115200
Digital reading range corresponding to the maximum level measurement value	1…4095
Digital reading range corresponding to the minimum level measurement value	0…1023
Temperature measuring range, °C	From -40 to +80
Absolute error in temperature measurement within the entire temperature measuring range, °С	±2

Omnicomm LLS-AF 4
Analog output:
Output voltage range, V	0…20
Maximum output voltage, V	5…20
Minimum output voltage, V	0…15
Digital-to-analog conversion resolution, bit	12
Load resistance on analog output, Ohm	Not less than 2000
Output signal pulsation, %	Not more than 0.15
Frequency output:
Output signal modulation:	Frequency pulse
Output frequency range, Hz	30…2000
Maximum output signal frequency, Hz	100…2000
Minimum output signal frequency, Hz	30…1900
Maximum load current at the frequency output in the “open collector” mode, mA	300
Resistance of the internal “pull-up resistor” to positive voltage supply, Ohm	1500

Спасибо!