Спасибо!

Мы исправим ошибку в ближайшее время

Сообщить об ошибке

Site Tools


Installation

SIM Card Inserting

Before SIM card inserting disable PIN request at activation. To this end insert the card in any cell phone and disable PIN request, according to the cell phone operating instruction.

  1. Push the terminal seal back
  2. Insert the SIM card into the connector until it clicks
  3. Return the seal to its original position

SIM-card installation

Wire Colour Designation

Omnicomm Smart terminal

Name of signal Designation Wire colour in cable
Ground (negative) for power supply Ground (power) Black
RPM input Tachometer Yellow
Not used NC Green
Not used NC White
Line B RS-485 B RS-485 Brown
Line A RS-485 A RS-485 Pink
Vehicle power supply voltage Power Red
Ignition key IGN Purple
Universal input 1 Input 1 Blue
Not used NC Grey
CAN Н CAN Н Orange
CAN L CAN L Yellow-green

Omnicomm Light terminal

Name of signal Designation Wire colour in cable
Ground (negative) for power supply Ground (power) Black
RPM input Tachometer Yellow
Controlled output 1 Output 1 Green
Not used NC White
Line B RS-485 B RS-485 Brown
Line A RS-485 A RS-485 Pink
Vehicle power supply voltage Power Red
Ignition key IGN Purple
Universal input 1 Input 1 Blue
Universal input 2 Input 2 Grey
CAN Н CAN Н Orange
CAN L CAN L Yellow-green

Power Supply and Ignition Key

Connect Omnicomm Smart and Light terminals as per diagrams without the ground disconnect switch: without ground disconnect switch before ground disconnect switch: after ground disconnect switch

after ground disconnect switch: before ground disconnect switch

Terminal

The terminal shall be installed inside the vehicle cabin on a flat surface or using a mounting plate.

GPS/GLONASS and GSM antennas are provided in the terminal, follow the recommendations for terminal’s positioning:

 Omnicomm Terminal location

We recommend to install it on the windshield or on the horizontal surface of the instrument panel in a place providing a good radio pick-up range of the sky.

Fasten the terminal to the surface with a double-sided adhesive tape.

When using a mounting plate, fix it on the surface with self-tapping screws. Fasten the terminal to the plate with a double-sided adhesive tape.