Спасибо!

Мы исправим ошибку в ближайшее время

Сообщить об ошибке

Site Tools


Panic Button

In the section “Panic button”:

In the field “Method of calculation”, select the parameter based on which Omnicomm Online software will record the panic button status.

Possible values depending on the type of the terminal being connected:

Always Switched off. This Method of calculation is a default value or is set up if it is not required to control the panic button status. Omnicomm Online software will always display no panic button actuations.

Flag “Panic button”. This Method of calculation is set up if the third-party terminal transmits information about the panic button status. Omnicomm Online software will record the pressing of the panic button when receiving a respective event from the third-party terminal.

From discrete input <N>. This Method of calculation is set up if the panic button is connected to a discrete input of the third-party terminal. Omnicomm Online software will record the panic button actuation when receiving the event of the discrete input on from the third-party terminal.

If it is required to record the panic button actuation when receiving the event of the discrete input off, tick the box “Invert”.