Спасибо!

Мы исправим ошибку в ближайшее время

Сообщить об ошибке

Site Tools


Tampering of the Device

In the section “Device tampering”:

In the field “Method of calculation”, select the parameter based on which Omnicomm Online software will record terminal tampering.

Possible values depending on the type of the terminal being connected:

“Always closed device”. This Method of calculation is a default value or is set up if it is not required to control tampering sensor status. Omnicomm Online software will always display no tampering of the device.

Flag “Device tampered”. This Method of calculation is set up if the third-party terminal transmits information about the tampering sensor status. Omnicomm Online software will record tampering of the device when receiving a respective event from the third-party terminal.

From discrete input <N>. This Method of calculation is set up if the tampering sensor is connected to a discrete input of the third-party terminal. Omnicomm Online software will record tampering of the device when receiving the event of discrete input on from the third-party terminal.

If it is required to record tampering of the case of the device when receiving the event of discrete input off, tick the box “Invert”.