Selection of Location to Install BIS 20240 (LLS20230)
1) Installation of BIS 20240 must be carried out outside of explosion hazard zone, on a smooth surface (e.g. cabin).
2) While selecting the location for installation, take into consideration the length of the cable intended to connect stabilitron-based spark protection unit BIS 20240 with an external device (e.g. FMS).
Note. Connection of BIS 20240 with fuel level sensor LLS 20230 should be made only by cable KTZ-XX produced by Omnicomm, where XX – cable length (which can be chosen within the range from 10 to 25m).