For Omnicomm LLS 4 sensors the bolt or self-tapping screw and the connection may be sealed:

1. Install the bolt or self-tapping screw through a hole in the seal

2. Close the seal cover with a snap

3. Enter the seal and cover numbers in the report

Put the sealing tie on the Omnicomm LLS 4 connector:

1. Connect the Omnicomm LLS 4 connector and the mounting cable connector until their typical clicking position
2. Run the seal flexible piece through the connectors
3. Run the seal flexible piece through the hole in the seal body
4. Tighten up the connection
5. Cut off the extended section of the seal flexible piece