Спасибо!

Мы исправим ошибку в ближайшее время

Сообщить об ошибке

Site Tools


Sealing

  • Place the casing-seal on the body of the sensor
  • Place the pins with the smaller diameter into the grooves of the casing-seal facing the protrusion of the casing and push them in as far as possible

Installation of the casing-seal

  • Connect the Omnicomm LLS-Ex 5 connector to the mounting cable until their typical clicking position
  • Run the flexible piece of the seal through the connectors
  • Run the flexible piece of the seal through the hole in the seal body

Installation of the sealing tie

  • Tighten up the connection
  • Cut off the protruding part of the flexible part of the seal