Спасибо!

Мы исправим ошибку в ближайшее время

Сообщить об ошибке

Site Tools


Preparation to installation on a fuel tank

1. Select a place for the sensor installation, taking in account the following:

A manner of sensor installation shall depend on the tank geometry, for reference please see the diagram:

Scheme of connecting the <k style='word-break:keep-all;white-space:nowrap'>Omnicomm LLD-HD</k> to the PC

Installation of the sensor in such manner ensures independence of the fuel level from the inclination of a vehicle. In cases, when it is impossible to install the sensor in the specified areas, the sensor installation place must be as close to them as possible.

Installation of two sensors in a fuel tank can significantly reduce dependence of the fuel level from the angle of inclination of vehicle:

Scheme of connecting the <k style='word-break:keep-all;white-space:nowrap'>Omnicomm LLD-HD</k> to the PC

2. To ensure the safety requirements are met, perform the tank ventilate.

3. Drill the center hole and four attachment holes.