Спасибо!

Мы исправим ошибку в ближайшее время

Сообщить об ошибке

Site Tools


Full/Empty Calibration

  1. Fill the calibration pipe with fuel.
  2. Immerse the Omnicomm LLS-HD sensor into fuel so that the probe is completely covered with fuel.
  3. Wait until the green indicator lights up “The level is stabilized”. In the “Settings” tab in the “Full/Empty calibration” section press the “Full” button, and a value corresponding to the full tank will be recorded.
  4. Remove the Omnicomm LLS-HD sensor from the tank and let the fuel drip from the probe. Please wait 1 minute at least. In the “Full/Empty calibration” section press the “Empty” button, and a value corresponding to the empty tank will be recorded.
  5. Press the “Save to sensor” button.