Спасибо!

Мы исправим ошибку в ближайшее время

Сообщить об ошибке

Site Tools


Omnicomm PORT Automatic Data Acquisition Module

General Information

The Omnicomm PORT Automatic Data Acquisition Module is onboard equipment designed for automatic data acquisition from Omnicomm Profi Wi-Fi terminals and data transfer to the Communication Server when connected to the Internet.

Main functions:

  • data collection from Omnicomm Profi Wi-Fi terminals version 2.0 and up using the Wi-Fi network
  • data storage in non-volatile memory
  • data transfer to Omnicomm Online or to third-party software via the Internet using Wi-Fi or third (3G) and fourth (4G) generation mobile networks

Starting from version 1.3.1, the Omnicomm Port firmware does not support settings configuration and reading of Omnicomm Profi Wi-Fi 3.0 terminals and firmware updates of Omnicomm Profi Wi-Fi 3.0 terminals.

If you need to configure/read the settings and update the firmware of Omnicomm Profi Wi-Fi 3.0 terminals, please use Omnicomm Configurator version 7.6.5 and above.

Operation

The Omnicomm PORT Automatic Data Acquisition Module installed on a vehicle collects data from Omnicomm Profi Wi-Fi terminals that operate outside the mobile network access area.

Omnicomm PORT connects to an existing Wi-Fi access point or mobile network and enables data transfer to the communication server and remote configuration server. When both Wi-Fi and mobile connection are available, data transfer is performed via the Wi-Fi network.

Operating Principle