Мы исправим ошибку в ближайшее время

Сообщить об ошибке

Site Tools

Driver Identification

In the “Settings” tab select the “Identification” section from the list.

Omnicomm Configurator

“Use for identification” – Omnicomm ICON

“Identification method” – select the method of identification. Possible options:

  • “Applying” – the identification is performed when a card or a key is applied for the period of time specified in the parameter “Key/card identification time”.
  • “Retention” – identification is performed by holding the card on the reader. This method is applied for identification via Omnicomm ICON display using the cardholder.

“Card identification duration” – specify the time value when iButton/card key is applied, after which will be enabled the second digital output of the terminal. Possible values: from 0 to 60 seconds.

In “Permitted cards” section, click “Add card” button and insert the card number. For automatic reading of the card number, connect Omnicomm ICON display to the terminal, switch on the readout mode and apply card.

If no card is indicated in this section, the events will be recorded for all applied cards.