Спасибо!

Мы исправим ошибку в ближайшее время

Сообщить об ошибке

Site Tools


Firmware Change Log

Date Firmware Version Changes
July 26, 2018 FW 305 - upgraded GPS connection (satellite loss, track gaps solved)
- failure after page reloading rectified
- track gaps in case of CS failure eliminated
January 14, 2019 FW 307 - solved factory reset issue when cleaning the terminal data archive or in case of on-board network voltage drop
- enhanced GPS communication (eliminated periodic coordinate discarding at 00-00 UTC)
- solved a problem of lack of communication with Profi Wi-Fi terminals, if there is a 0 in IP-address (for example, 192.168.0.1)
- rectified freezing of Omnicomm LLS-AF fuel level sensor values when the terminal switches to Collect all except GPS mode
March 20, 2019 FW 308 - implemented the function of collecting arbitrary CAN-parameters from VH operating according to FMS, and displaying CAN data in Omnicomm Online
- terminal factory reset eliminated
- solved failures of terminal time stamps, VID, PID
- added protection from satellite loss due to QZSS (Japanese Quasi-Zenith Satellite System)
- implemented the function of the terminal calling back to the number in case of bad voice connection
October 31, 2019 FW 309 - a new speed filtration algorithm when selecting GPS data source developed
- it is now possible to transfer data to 3 Communication Servers simultaneously (except for Smart)
- a possible period of data collection has been decreased to one time per 1 second (except for Smart)
- now up to 2 digital LLS fuel level sensors can be connected to Smart terminals, and up to 4 digital sensors – to Light
- GSM signal level is displayed now
- ContiPressureCheck tyre pressure monitoring system now supported
- accelerometer calibration state is now displayed at the Remote Configuration Server
- the number of geofences has been increased to 60, and the number of points to 240