LED and Sound Notification
| Indicator | Indication mode | Value |
|---|---|---|
| Power red/green | Out | Power: absent |
| Alternately flashes red-green | Off Power: Main Ignition: Off Operating Mode: “Collect all data except GPS“ |
|
| Flashing red at interval 4 times per second | Power: from USB (if there is charger backup battery) | |
| Permanently lighted green | Power: main Ignition: On or Power: Main Ignition: Off Operating mode “Collect all data” |
|
| Flashing red at interval 1 time per two seconds | Power: Main or backup battery (if any) Ignition: Off Operating mode: «Sleeping» |
|
| GPS red/green | Off | Module power supply off |
| Alternately flashes red/green | In case of module failure, the indicator “Accident” is lighted | |
| Permanently lighted green | Valid data from satellites are recieved | |
| Permanently lighted red | No data reception from satellites or invalis data recieved | |
| GSM red/green | Off | Module power supply off |
| Permanently lighted red | Out of coverage or GSM network search | |
| Permanently lighted green | Within the GSM network coverage, exchange with communication server through GPRS channel is not performed | |
| Flashing red | Module activation. Module switches to working mode | |
| Flashing green | Active GPRS session. No exchange with communication server through GPRS channel | |
| Flashing orange (simultaneous flashing red and green indicator) | Within the GSM network coverage, available data exchange with communication server through GPRS channel | |
| Alternately flashes red-green | Module error | |
| Accident red/green | Off | No failures |
| Permanently lighted red | Failure in operation (damage) of internal elements, satellite navigation module or GSM module | |
| Alternately flashes red-green | Failure of exchange with one or more Omnicomm LLS sensors | |
| Check Omnicomm LLS settings, communication lines, Omnicomm LLS power supply voltage as per “User Manual Omnicomm LLS 20160, LLS 30160,LLS4, LLS 20230” | ||
| Power and Accident | Simultaneously flashing red at с interval 1 time per second | Terminal is locked. Contact your dealer |
| * Note: in case of internal fault (the “Accident” indicator is on), the failure of GSM modules and satellite receiver can be assessed by the status of indicators. | ||
Sound notification for Omnicomm Profi Wi-Fi terminal
| Number of sound signals | Designation |
|---|---|
| One beep | The terminal has connected to a Wi-Fi access point that was specified when configuring the terminal |
| Two beeps | Terminal has disconnected from Wi-Fi access pointk |
| Three beeps | The terminal has finished data transmission over the Wi-Fi network |
