You are currently not logged in! Enter your authentication credentials below to log in. You need to have cookies enabled to log in.
SIM Card Inserting
Before SIM card inserting, disable PIN request at activation. To this end insert the card in any cell phone and disable PIN request, according to the cell phone operating instruction.
If using commands in SMS messages, enable the Short Message Service.
Insert the SIM card into the connector, contacts down, until it clicks.
Connector Pin Assignment
|No. of pin||Designation|
|4||Vehicle body grounding|
|6||CAN-High wire of the high-speed bus CAN Highspeed (ISO 15765-4, SAE-J2284)|
|7||K-Line (ISO 9141-2, ISO 14230)|
|14||CAN-Low wire of the high-speed bus CAN Highspeed (ISO 15765-4, SAE-J2284)|
|15||K-Line (ISO 9141-2, ISO 14230)|
|16||Battery power supply, +12 / + 24 V|
Connect the terminal to the connector of vehicle's OBDII.
To achieve the high accuracy of VH geolocation and the faster search for satellites after turning on the ignition, the location of the OBDII terminals should ensure a good radio coverage of the horizon. If necessary, use an OBD extension cable.