Send new password
Please enter your user name in the form below to request a new password for your account in this wiki. A confirmation link will be sent to your registered email address.
SIM Card Inserting
Before SIM card inserting, disable PIN request at activation. To this end insert the card in any cell phone and disable PIN request, according to the cell phone operating instruction.
If using commands in SMS messages, enable the Short Message Service.
Insert the SIM card into the connector, contacts down, until it clicks.
Connector Pin Assignment
| No. of pin | Designation |
|---|---|
| 4 | Vehicle body grounding |
| 5 | Signal grounding |
| 6 | CAN-High wire of the high-speed bus CAN Highspeed (ISO 15765-4, SAE-J2284) |
| 7 | K-Line (ISO 9141-2, ISO 14230) |
| 8 | Not used |
| 14 | CAN-Low wire of the high-speed bus CAN Highspeed (ISO 15765-4, SAE-J2284) |
| 15 | K-Line (ISO 9141-2, ISO 14230) |
| 16 | Battery power supply, +12 / + 24 V |
Terminal Connection
Connect the terminal to the connector of vehicle's OBDII.
To achieve the high accuracy of VH geolocation and the faster search for satellites after turning on the ignition, the location of the OBDII terminals should ensure a good radio coverage of the horizon. If necessary, use an OBD extension cable.
